Group: Administrator
Level:
Posts: 4873
Joined: 1/28/2015
IP-Address: saved
|
mortise joint depends on tight, are not allowed to leave a gap between plates. 7, the expansion of the edge with 8 mm - 10 mm wide gap. 8, the bottom of the plate space around and padded to plywood good wood panel of exterior cladding wall , allow low 0.5 mm more than elevation lines are not allowed to make the plate with gasket.
floor installation will plastic film on the panel, expand clearance of debris to clean up. 10, excess plastic film under the skirting board with the blade is clean. The floor on a layer of senior cerate timber wall panels interior price , plates in the decorative thread must covered with wax.
in a heating environment or low temperature radiation heating of the heat of the ground shop, require tongue-and-groove mortise agglutination, glue to apply enough amount, coating, coating evenly nonskid wood texture composite panels canada . Will tenon groove with the tensioning device by tight squeeze out uniform glue line, tensioning device for pressure relief after keep 8-10 mm.
|
Search 
Calendar 
Gallery
Auctions 
Global 
Top
Members 
Stats
Chat (0) new 
send Password 
Register
