Group: Administrator
Level:
Posts: 4873
Joined: 1/28/2015
IP-Address: saved
|
A joint cut or tooled into the concrete surface to control the location of cracks. A control joint in the tile to be located above the control joint in the substrate or above any construction cold joints. Saw cuts to be applied within the first twelve hours of concrete placement. A joint in the ceramic tile, extending through the setting materials which is intended to minimize stresses in the bond layer due to differential movement of ceramic tile relative to the substrate, caused by thermal expansion and contraction.outside flooring materials Saw cuts to penetrate a minimum of 1/3 of the thickness of the slab. Saw cutting of the slab is not the responsibility of the tile contractor. Control joints to be provided around the perimeter of floors, around columns, where tile abuts other hard materials, at the junction between horizontal and vertical surfaces and at transitions that include corridors and changes in direction, for example T��s, L��s and diagonals.
The location of expansion joints and control joints is the responsibility of the consultant. Exterior expansion or control joints to be caulked with suitable sealants. For interior expansion or control joints, prefabricated expansion joints or double metal or plastic terrazzo strips may be used with a suitable sealant. Some prefabricated expansion joints may be recommended by the manufacturer for exterior use. Cold Joint �C Cold joints are formed primarily between slab pours. A control joint to be installed over all cold joints in the slab. cheap Wood plastic Composite flooringWhere conditions do not allow one to install a control joint, the use of a crack isolation membrane may be considered, along with a control joint in the tile surface as close as possible to the cold joint in the substrate. Construction Joint �C The plane where two successive placements of concrete meet but do not bond cementitiously. Sometimes dowels or reinforcing steel are used to hold the concrete on both sides together.
A control joint to be placed over this joint in the tile. Isolation Joint �C A separation between adjoining similar or dissimilar elements of a concrete structure, usually a vertical plane. Its purpose is to prevent movements of the individual parts from causing cracks in the concrete. Also, sometimes called an expansion joint. Structural Joint �C An isolation joint intended to allow independent movement between adjoining sections of the building. Apply scratch coat and allow to cure a minimum of 24 hours at 20o C. Buy Flooring & Tiles OnlineApply mortar bed to required thickness in an even plane. Finished tolerance of mortar bed not to exceed 6 mm in 3049 mm or 2 mm in 305 mm. Allow up to 72 hours to cure. Apply bond coat to mortar bed surface. Slide tile firmly into position. Use sufficient bond coat to ensure minimum 95% contact on exterior surfaces and wet areas and minimum 80% on interior dry surfaces. Force grout into full depth of joint, remove excess grout and clean.
|
Search 
Calendar 
Gallery
Auctions 
Global 
Top
Members 
Stats
Chat (0) new 
send Password 
Register
