Group: Administrator
Level:
Posts: 4873
Joined: 1/28/2015
IP-Address: saved
|
What is the reason sometimes wooden floor will house a partial bagging phenomenon,timber decking material this phenomenon is it? How to prevent such a phenomenon? Bagging wood flooring must first understand the reasons, in order to achieve a fundamental preventive measures . Causes wood floor bagging What reason: the moisture content of the surface layer of wood flooring is low or low; if the moisture content is low, after the paved floor, wood will absorb moisture from the air, it will cause? bagging the floor, if the moisture content is high, if the dry air, the floor will lose moisture, causing necking occurs tilt deformation.
Two reasons: to fill in between the wood joists shop fine stone concrete, insulation or sound insulation materials, concrete or material does not dry after Puwan floor, the floor will absorb moisture, high density synthetic lumber then will be deformed from the drum. Three reasons: the floor around the vent hole is not left or laying no vapor barrier, so lay back laminate can not be excluded because the internal moisture will cause bagging phenomenon. Four reasons: the subfloor is not opened, or opened the gap a little gap, so that the expansion floor after damp, ventilation is impossible, that is, the panel was bagging deformation.
How to prevent a wooden floor bagging points: Del laying wood flooring moisture content to take a grip, not too high or too low, the moisture content should not be greater than 12%. Point # 2: Irrigation in concrete or laying noise insulation material between the wood joists, must have after drying, then laying the floor. Highlights three: vent need a reasonable set, how to refurbish a composite top bench wooden joists to achieve communication between the slot holes, but also the pain connected to vent floor surface, so as to ensure the floor ventilation ventilation, and air vent floor surface layer can not be less than two, baseboards vent on each side of not less than two, the last is that each vent should be kept open so that it can help air circulation.
Highlights four: subfloor (referring to the lower wooden floor) of the slab should be an appropriate distance, typically 2-5 mm, on the surface to be planed,environmental protection patio furniture adjacent seams to stagger around from the wall the distance should be 10-15 mm. Highlights five: the gap between the wood surface and the wall should leave 10 mm, then kicked the skirting board or strip is carried out cover.
|
Search 
Calendar 
Gallery
Auctions 
Global 
Top
Members 
Stats
Chat (0) new 
send Password 
Register
