Group: Administrator
Level:
Posts: 4873
Joined: 1/28/2015
IP-Address: saved
|
Pavement leveling the ground is key: before making geothermal wood hardware lattice panels floor coverings, the room must meet the following conditions can be carried out paving work. The ground must remain flat, indoor environment dry and no water seepage, leakage and other phenomena occur, drain kept clear. The most vulnerable part of the above question is ground flatness problem. If the ground level is not only for the old house, some pre-construction new homes caused by inadequate uneven ground, it is also required for leveling work. Whether the ground needs leveling interior floor manufacturers flooring generally consists responsible remind the owners, if laid side before laying did not do to remind the obligation, to find the problem after the pavement is caused by uneven ground, it shall bear the corresponding responsibility. Prior to the pavement while also check ground clearance and Door leaf. Door and the ground should maintain a certain distance, otherwise it will rub the ground. Paving workers but also ensure that the 6ft fence panels floor after completion of the pavement for 5 mm gap with the ground, if it is less than 5 mm will cause inconvenience to the door switch. And in the laying of the cushion, and the direction of the floor mat to vertical.
When watching the trial flooring Gap distance: during geothermal floor coverings, the first three rows are required to test the shop, that can not be sizing pavement. In terms of the direction of the pavement is not strictly required, generally along the length of the room pavement, if the owners have special requirements, can also be based on the feasibility pavement. Row by row from left to right should ensure the pavement grooves toward the wall, placed between the wood panelling for outdoors floor and the wall of the wedge to leave some gaps stretching, stretching the gap should be maintained between 8-12 mm. Note also that in the pavement, if the last row of a cutting remaining portion of the floor greater than 200 mm, must be used for the next row of the starting block, in order to ensure a certain area and adjacent plates wrong seam wrong seam ends greater than 200 mm and less than 200 mm if you can give.
|
Search 
Calendar 
Gallery
Auctions 
Global 
Top
Members 
Stats
Chat (0) new 
send Password 
Register
